Release Notes for Descon Version 8.1.0.022
November 2026
The bolts of a column splice are now dimensioned from the end of the column they are in, with or without an end gap. They had been measured from a point that did not match either column end.
Also in this version:
- The vertical bolt dimensions of a column splice are on one side of the drawing, with the end distance outside the bolt spacing
- With an end gap, the lower flange fillers of a column splice are drawn against the lower column's end
- When the plates of a column splice are welded to a column, that column shows no bolts, and the plate callouts give the fillet weld to that column. The web gage dimensions are drawn on the bolted column
- The upper column of a column splice is drawn with a vertical centerline
- Descon no longer closes at start-up with "Error creating license. (CODE 3)" when the license request does not get through. It asks again. If there is still no answer, it opens on this computer's license or at the license form
- When Descon cannot start, the error code names the step that failed: DS08 for the license, DS09 for the data files in Documents\Descon\ProgramData, DS10 for the drawing window. The reason is saved with the code, so a report sent from the error carries it. Send Feedback is available there, and the report sends without an open design
To update, open Descon and click Approve when the prompt appears.
If you do not get a prompt, go to the Support tab and click Update.
If the license is past its expiration date, contact us and we can help you renew.